Promotions
The GW Instek GLN-5040A Line Impedance Stabilization Network is used for EMI testing. It provides a stable impedance for the EUT terminals and the reference ground within the conducted emissions range.
The GW Instek GLN-5040A Two Line V-Network is used for EMI testing. It provides a stable impedance for the EUT terminals and the reference ground within the conducted emissions range. The GW Instek GLN-5040A also isolates the unwanted network signals from the power supply unit and only couples the disturbance voltage of the measured device to the receiver.
The GW Instek GLN-5040A performance is in compliance with the standard requirements of CISPR16-1-2 for V-networks with a simulated impedance of 50μH + 5 Ω) || 50 Ω in the frequency range of 9kHz to 30MHz.
The GLN-5040A uses standard BNC output connector with 50 Ω output impedance to match any measurement devices such as receivers and spectrum analyzers.
It is equipped with an artificial hand function that simulates a handheld type measurement, a 9kHz and 150kHz high pass filter selection function that allows the product to select the correct filters according to the relevant standard.
The GLN-5040A is also suitable for signal phase device conduction (disturbance voltage) measurement. Due to design principles, there may exist a great deal of leakage current. It is recommended that the unit is grounded when used, and if necessary, it should also be used with an isolation transformer.
Features
- EMI testing for EMI/EMC Pre-Compliance
- Provides stable impedance for EUT terminals and reference ground within conducted emissions range
- Isolates unwanted network signals from power supply unit
- Only couples disturbance voltage of measured device to receiver
- In compliance with standard requirements of CISPR16-1-2
- Uses standard BNC output connector with 50 ohm output impedance
- Matches any measurement devices such as receivers and spectrum analyzers
- Equipped with artificial hand function that simulates handheld type measurement
- 9kHz and 150kHz high pass filter selection function that allows product to select correct filters according to relevant standard
- Suitable for signal phase device conduction (disturbance voltage) measurement
Applications
- Laboratories
- Production/Manufacturing
- Workshops
- Research and Development
