REED R5030 AC/DC True RMS Clamp Meter

REED R5030 AC/DC True RMS Clamp Meter

With a non-contact AC voltage detector in it’s clamp tip the Reed R5030 clamp meter becomes a quick and versatile diagnostic tool for finding out why an electrical system or piece of electrical equipment is not operating correctly.

Applications for the REED R5030

• Industrial maintenance technicians
• Control technicians
• Electricians
• Facilities
• Building maintenance and HVAC technicians
• Repairing existing systems on an as-needed basis
• Troubleshoot installation problems
• Perform final circuit tests
• Perform scheduled and preventive maintenance on electro-mechanical and electrical systems
• Industrial equipment and controls
• Commercial/industrial HVAC systems

AC/DC Current Clampmeter
Range	50.00, 500.0A
Accuracy	AC: ±(2.8% rdg. +30 dgt.) DC: ±(2.5% rdg. +30 dgt.)
AC/DC Voltage
Range	AC: 500.00mV, 5.0000, 50.000, 500.00, 750.0V DC: 500.00mV, 5.0000, 50.000, 500.00, 1000.0V
Accuracy	AC: ±(1.0% rdg. +30 dgt.) DC: ±(0.1% rdg. +4 dgt.)
Resistance
Range	500.00Ω, 5.000, 50.000, 500.00kΩ, 5.0000, 50.000MΩ
Accuracy	±(1.0% rdg. +4 dgt.)
Frequency
Range	10.000kHz
Accuracy	±(0.5% rdg. +10 dgt.)
Capacitance
Range	500.00, 5000.0nF, 50.00, 500.0µF, 5.000mF
Accuracy	±(3.5% rdg. +10 dgt.)
Temperature
Range	-100.0 to 1000.0°C/-148.0 to 1832.0°F
Accuracy	±(1.0% rdg. +2.5°C/4.5°F)
General Specifications
Display	50,000 count LCD
Power Supply	Two AAA 1.5V batteries
Jaw Opening	30mm
Dimensions	198 x 66 x 36mm
Weight	230g

What’s included with the REED R5030

• R5030 500A AC/DC True RMS Clamp Meter
• Set of Test Leads
• Temperature Probe
• Batteries
• Soft Carrying Case

Battery Replacement

1. Remove the Phillips screw on the back of the meter

2. Open the battery compartment

3. Replace the dead batteries and close the battery compartment

Safety

• Do not exceed the maximum allowable input range of any function

• Do not apply voltage to the meter when resistance function is selected

• Set the function switch OFF when the meter is not in use Warning

• Set the function switch to the appropriate position before measuring

• When measuring volts do not switch to current/resistance modes

• When changing ranges using the selector switch always disconnect the test leads from the circuit under test

• Do not exceed the maximum rated input limits